Tribeca F6-3.6L (2008)
1) Check the rear wheel bearing play and axle hub runout before inspecting the disc rotor runout limit.
2) Secure the disc rotor by tightening the five wheel nuts.
3) Set a dial gauge 10 mm (0.39 in) inward from the disc rotor outer circumference. Rotate the disc rotor to check runout. If the disc rotor runout
exceeds the limit, resurface the disc rotor. After resurfacing, check disc rotor thickness as in step 4).
Disc rotor runout limit: 0.05 mm (0.0020 in)
4) Set a micrometer 10 mm (0.39 in) inward from the disc rotor outer perimeter, and then measure the disc rotor thickness. If the thickness of the disc
rotor exceeds the service limit, replace with a new disc rotor. Specification Limit Disc rotor outer diameter