Tribeca F6-3.6L (2008)
Vacuum Pump: Service and Repair
Brake Vacuum Pump
REMOVAL
BRAKE VACUUM PUMP
1) Disconnect the ground cable from the battery.
2) Disconnect the brake vacuum pump connector.
3) Remove the vacuum hose.
4) Remove the bolt, and remove the brake vacuum pump.
VACUUM HOSE
Remove the clip and remove the vacuum hose.
INSTALLATION
BRAKE VACUUM PUMP
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.76 kgf-m, 5.5 ft-lb)
VACUUM HOSE
Install in the reverse order of removal.
CAUTION: The vacuum hose has an installation direction. Make sure to install in the proper direction.
INSPECTION
BRAKE VACUUM PUMP
Inspect for whether or not the pump operates when battery voltage is applied to the connector terminal.
VACUUM HOSE
Check to see that air only flows in one direction, when air is blown into or sucked from the hose.