Tribeca F6-3.6L (2008)
Oil Pressure Sender: Service and Repair
Oil Pressure Switch
REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the terminal from oil pressure switch.
6) Remove the oil pressure switch.
INSTALLATION
1) Apply liquid gasket to the oil pressure switch threads.
Liquid gasket. THREE BOND 1324 (Part No. 004403042) or equivalent
2) Install the oil pressure switch.
Tightening torque: 25 N-m (2.5 kgf-m, 18.4 ft-lb)