subaru Workshop Repair Guides

Subaru Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 3
background image

5) Remove the front and rear cushion rubber, and then remove the muffler.

INSTALLATION 

Install in the reverse order of removal.

NOTE:  
^

Use a new gasket and self-locking nut.

^

After assembling, degrease the lubricant which was applied to the cushion rubber while removing/ installing.

Tightening torque: 48 N-m (4.9 kgf-m, 35.4 ft-lb)
^

LH side

^

RH side

INSPECTION 

1) Check the connections and welds for exhaust leaks.
2) Make sure there are no holes or rusting.
3) Check the cushion rubber for wear or crack.

Engine, Cooling and Exhaust > Exhaust System > Muffler > Component Information > Service and Repair > Page 1411

< PREV PAGE NEXT PAGE >