Tribeca F6-3.6L (2008)
CAUTION: When replacing the evaporator, add an appropriate amount of compressor oil to the evaporator.
2. REAR
1. Using the refrigerant recovery system, discharge the refrigerant.
2. Disconnect the ground cable from the battery.
3. Remove the rear cooler unit.
4. Remove the pipe bracket bolts and remove the bracket.
5. Remove the screws, and then remove the cooler unit.
6. Remove from the cooler unit and disconnect the tube from the evaporator.
CAUTION: When replacing the evaporator, add an appropriate amount of compressor oil to the evaporator.
INSTALLATION
Install in the reverse order of removal.
CAUTION: Route the cord (A) of the evaporator through the location shown on the illustration.