Tribeca F6-3.6L (2008)
3) If it is not within the specification, adjust it by adjusting the position of the stop light switch.
CAUTION: Be careful not to rotate the stop light switch.
RESISTANCE CHECK
1) If stop light switch does not operate normally, replace it to a new part.
2) Measure the resistance of the stop light switch.
ADJUSTMENT
Loosen the lock nut, and adjust the stop light switch position until the clearance between the threaded end of the stop light switch and stopper (A)
becomes 0.8 mm (0.031 in). Then, tighten the lock nut.
Tightening torque: 8 N-m (0.8 kgf-m, 5.8 ft-lb)
NOTE: Tighten lock nut B until the threaded end of switch contacts the stopper. Hold the switch so that it does not rotate, and loosen the lock nut B