Tribeca F6-3.6L (2008)
Combination Switch: Service and Repair
Combination Base Switch Assembly
Combination Base Switch Assembly
REMOVAL
1. Remove the driver's airbag module.
2. Remove the steering wheel.
3. Remove the screws and remove the steering column lower cover.
4. Remove the combination switch.
5. Remove the four screws and remove the roll connector.
6. Remove the three screws.
7. Disconnect the connector and remove the combination base switch assembly.
INSTALLATION
1. Install in the reverse order of removal.
2. Before installing steering wheel, be sure to adjust the direction of roll connector with steering.
