Tribeca F6-3.6L (2008)
Wheel Bearing: Service and Repair
Front Hub Unit Bearing
Front Hub Unit Bearing
REMOVAL
1. Disconnect the ground cable from the battery.
2. Lift-up the vehicle, and remove the front wheels.
3. Lift the crimped section of axle nut.
4. Remove the axle nut using a socket wrench while depressing the brake pedal.
CAUTION: Remove the wheel before loosening the axle nut. Failure to follow this rule may damage the wheel bearings.
5. Remove the disc brake caliper from the front housing, and suspend it from strut using a piece of wire.
6. Remove the disc rotor from the hub.
NOTE: If it is difficult to remove the disc rotor from the hub, drive the 8 mm of bolt into the threaded end of rotor, then remove the rotor.
7. Remove four bolts from the front housing.
CAUTION:
^
Do not get closer the tool which charged magnetism to magnetic encoder.
^
Be careful not to damage the magnetic encoder.
