Tribeca F6-3.6L (2008)
10) Measure the clearance of intake valve and exhaust valve using thickness gauge (A).
NOTE:
^
Measure it within the range of ±30' from specified position shown in the figure.
^
Insert a thickness gauge in a direction as horizontal as possible with respect to the valve lifter.
Valve clearance:
Intake: 0.20 +0.04 -0.06 MM (0.0079 +0.0016 -0.0024 in)
Exhaust. 0.35 ± 0.05 mm (0.0138 ± 0.0020 in)
If the measured value is not within specification, take notes of the value in order to adjust the valve clearance later on.
11) If necessary, adjust the valve clearance.
12) Further turn the crank pulley clockwise and then measure the valve clearances again.
13) After inspection, install the related parts in the reverse order of removal.
