Tribeca F6-3.6L (2008)
-
Make sure the sealing portion is free from fuel or foreign matter before installation.
-
Align the protrusion (A) of gasket to the position shown in the following figure.
-
Align the protrusion (B) of fuel sub level sensor with the cutout portion of fuel sub level sensor upper plate.
-
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
NOTE: Use a new gasket and retainer.
Tightening torque: 4.4 N.m (0.45 kgf.m, 3.2 ft.lb)
