Tribeca F6-3.6L (2008)
Battery: Service and Repair
Battery
REMOVAL
1. Disconnect the positive (+) terminal after disconnecting the negative (-) terminal of battery.
2. Remove the flange nut from battery rod and remove battery holder.
3. Remove the battery.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 3.4 N.m (0.35 kgf.m, 2.5 ft.lb)
NOTE:
-
Clean the battery cable terminals and apply grease to retard the formation of corrosion.
-
Connect the positive (+) terminal, and then connect the negative (-) terminal of the battery.
-
Initial diagnosis of electronic throttle control is performed after battery installation. Because of this, start the engine 10 seconds or more after the
ignition switch is turned ON.