Tribeca F6-3.6L (2008)
Fluid Line/Hose: Service and Repair
Removal
ATF Cooler Pipe and Hose
REMOVAL
1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Remove the under cover.
4) Disconnect the ATF cooler hose from the radiator.
NOTE:
^
Do not use a screwdriver or other pointed tools.
^
If it is hard to remove the hose, wrap the hose with cloth to prevent from damaging it, and while turning with pliers, pull straight out by hand.
5) Disconnect the ATF cooler hoses from the pipes.
NOTE:
^
Do not use a screwdriver or other pointed tools.
^
If it is hard to remove the hose, wrap the hose with cloth to prevent from damaging it, and while turning with pliers, pull straight out by hand.
6) Remove the front bumper.
7) Remove the ATF filter inlet and outlet hoses.
8) Remove the bolts securing the ATF cooler pipe, and remove the ATF cooler hose.
