Tribeca F6-3.6L (2008)
Transmission Speed Sensor: Service and Repair
Turbine Speed Sensor 1
Removal
Turbine Speed Sensor 1
REMOVAL
1) Remove the air intake chamber and intake boot.
2) Lift up the vehicle.
3) Disconnect the turbine speed sensor 1 connector.
4) Remove the turbine speed sensor 1.
Installation
INSTALLATION
1) Install the turbine speed sensor 1.
Tightening torque:
7 N-m (0.7 kgf-m, 5.2 ft-lb)
2) Connect the turbine speed sensor 1 connector.
3) Lower the vehicle.
4) Install the air intake chamber and intake boot.