Tribeca F6-3.6L (2008)
Drive/Propeller Shaft: Service and Repair
Installation
INSTALLATION
1) Insert the sleeve yoke into the transmission and attach center bearing to body.
Tightening torque:
52 N-m (5.3 kgf-m, 38.3 ft-lb)
2) Align the alignment marks and connect the flange yoke and rear differential.
Tightening torque:
31 N-m (3.2 kgf-m, 23.1 ft-lb)
3) Install the heat shield cover.
4) Install the center exhaust pipe.
5) Install the rear exhaust pipe and muffler.
6) Lower the vehicle.
7) Connect the ground cable to battery.
