Tribeca F6-3.6L (2008)
Control Module: Service and Repair
Installation
INSTALLATION
1) Install the TCM.
Tightening torque:
7.5 N-m (0.8 kgf-m, 5.5 ft-lb)
2) Connect the connector to the TCM.
3) Install in the reverse order of removal.
4) Perform Clear Memory 2 operation. See: Transmission Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/Clearing Diagnostic Trouble Codes
5) Execute the learning control promotion. See: Transmission Control Systems/Testing and Inspection/Programming and Relearning
6) Perform the inspection at the end of repair work, and make sure there is no faulty as below;
^
Excessive shift shock
^
Oil leakage from the transmission body, etc.
^
Occurrence of noise caused by interference etc.
