XT-6 2WD L6-2.7L SOHC (1989)
Splash Guard: Technical Service Bulletins
Mudflap - Installation Procedure
NUMBER 15-63-88
DATE
10-10-88
ALL "89 MY VEHICLES EXCEPT JUSTY AND
APPLICABILITY
CARRYOVER MODELS
PLEASE REFER TO TSB # 156789, DATED 1/30/89 FOR MORE INFORMATION
SUBJECT:
MUDFLAP INSTALLATION PROCEDURE
This Bulletin Should be Used to Update the Installation Instructions of the Current Inventory of Mudflaps Listed Below:
Part Number
Application
Qty. (Per Kit)
SOA465L100
L-Series FWD
4
SOA465L101
L-Series 4WD
2
SOA367L100
XT
All
4
The 1989 Model Year 4 Dr. Sedan, 3 Dr. Coupe, Station Wagon and XT vehicles have black chip protectors on the wheel opening fender flange areas.
The chip protectors cover the mudflap mounting area and holes.
FIGURE 1
To install the mudflaps use the following procedure:
^
Align the mudflap on the fender
^
Mark the top of the mudflap on the chip protector
^
Pry-off the button located at the bottom of the chip protector
^
Using a pair of diagonal cutters cut-off the marked section of the chip protector where the mudflap mounts to the fender by cutting between the
metal retaining teeth. See Figure 1.
CAUTION: BE CAREFUL NOT TO CHIP THE PAINT ON THE FENDER FLANGE WHILE CUTTING THE SECTION OF CHIP
PROTECTOR.
^
Make sure the remaining section of the chip protector on the fender is securely in place.
^
Install the mudflaps according to the instructions found in the mudflap kit. See application chart above.