XT-6 2WD L6-2.7L SOHC (1989)
Refrigerant Oil: Service and Repair
Fig. 8 Oil Charge Table. XT Models
Compressor lubrication oil circulates with refrigerant while the system is operating. If significant refrigerant is lost, check oil level as follows:
1.
Set A/C controls for maximum cooling and high blower speed.
2.
Operate engine at 1000 - 1500 rpm for approximately 10 minutes.
3.
Stop engine and discharge system.
4.
Remove compressor from vehicle.
5.
Drain oil from compresor into a premeasured container. On Diesel Kiki models, drain oil through drain plug. On Calsonic models, drain oil
through suction and delivery ports. Rotate clutch hub two or three times to completely drain oil.
6.
Refer to Fig. 8 for amount of oil to be added or removed. A new compressor contains 150cc of oil. Drain 80cc of oil from new compressor or
adjust amount of oil to equal that from old compressor.
7.
If adding oil, pour premeasured oil into compressor suction port with aid of a funnel.
8.
Install compressor, then evacuate and recharge system.
