XT-6 2WD L6-2.7L SOHC (1989)
lines as sow residual pressure will remain. Use of protective eyeware is recommended. The fuel pump remains unplugged during the cleaning
process.
^
Using the 5/16" male hose end fitting, correct the fuel injector cleaner directly to the most accessible underhood fuel line location, usually at the
discharge side of the fuel filter. Always hook in after the fuel filter to prevent running cleaner through the filter.
^
The vehicles fuel return line must be blocked to prevent cleaning fluid from entering the fuel tank. Use pinching pliers on the return hose or
remove the line and physically plug. It is important that cleaning fluid does not anter the fuel tank.
^
Limit reservoir tank pressure to 20 psi, not 25 as stated in the Kent-Moore instructions.
^
Cleaning procedure can be repeated if necessary, however no more than three cleanings should be performed at one time.
^
After completing the cleaning operation, close the needle shut-off valve and run engine until it stalls to purge engine of cleaning fluid.
^
Follow the instructions and recommendations included with the cleaner except for the exclusions noted in this bulletin.
^
This item can be ordered from Kent-Moore directly by using their toll free number, 1-800-345-2233.
