XT-6 2WD L6-2.7L SOHC (1989)
Ignition Control Module: Description and Operation
Ignitor
Ignition Control System
PURPOSE
Controls ignition discharge by interrupting the ignition coil primary current ground. The ignitor is a solid state component.
LOCATION
On the left strut tower.
OPERATION
The ignitor is a switching device used to interrupt the ignition coil ground connection and induce high voltage from the coil secondary windings.
A signal from the ECU controls ignitor switching, enabling the ECU to regulate ignition timing based engine operating condition information
received from various sensors.
