Aerio L4-2.0L (2002)
CAUTION:
^
Wash each part cleanly before installation in the same fluid as the one used in master cylinder reservoir.
^
Never use other fluid or thinner.
^
Before installing piston seal or cylinder boot to cylinder, apply grease to them.
^
Install a new piston seal into groove in cylinder securely making sure that it is not twisted.
^
Before installing caliper to carrier, install slide pin with grease applied into caliper carrier hole and check for its smooth movement in thrust
direction.
^
After reassembling brake lines, bleed air from them.
^
Install piston seal, boot, piston and retaining ring to caliper.
1. Replace with a new piston seal (1) at every overhaul. After applying grease, fit piston seal (1) into groove in cylinder taking care not to twist it.
2. Before inserting piston (2) into cylinder, apply grease to new boot (1) and install it onto piston as shown.
"A": 1-grooved side directed cylinder side
"B": 2-grooved side directed pad side
3. Fit boot as it is in figure into boot groove in cylinder with fingers.