Aerio L4-2.0L (2002)
Seat Belt Retractor: Description and Operation
Seat Belt Construction
General Description
Seat Belt with ELR
The seat belt with emergency locking retractor (ELR) is designed so that it locks immediately (to prevent the webbing from being pulled out of the
retractor any further) when any of the following items is detected as exceeding each set value;
-
Speed at which the webbing is pulled out of the retractor.
-
Acceleration or deceleration of the vehicle speed.
-
Inclination.
Seat Belt with A-ELR
The automatic and emergency locking retractor (A-ELR) works as an Emergency Locking Retractor (ELR) till its webbing is pulled all the way out and
then on as an Automatic Locking Retractor (ALR) till it is retracted fully. ALR: Automatically locks when the webbing is pulled out from the retractor
and allowed to retract even a little. Then the webbing can not be pulled out any further, unless it is wound all the way back into the retractor, which
releases the lock and allows the webbing to be pulled out.
Seat Belt with ELR and Pretensioner
The seat belt with ELR and a pretensioner has a pretensioner mechanism which operates in linkage with the air bag in addition to the described ELR.
The pretensioner is incorporated in retractor assembly and controlled by SDM as one of air bag system components. It will be activated at the same time
as the air bag when an impact at the front of vehicle exceeds the specified value.
When servicing seat belt (retractor assembly) with pretensioner, be sure to observe all WARNINGS and CAUTIONS in this section and "Precautions on
Service and Diagnosis of Air Bag System".
CAUTION: Do not reuse the seat belt pretensioner (retractor assembly) that has operated. Replace it with a new seatbelt assembly and buckle together