Aerio L4-2.3L (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement
Front
Removal
1. Disconnect negative cable at battery.
2. Disconnect front wheel speed sensor coupler (1).
3. Hoist vehicle and remove wheel.
4. Remove harness clamp bolts (2) and grommet (3).
5. Remove front wheel speed sensor (4) from knuckle.
CAUTION:
-
Do not pull wire harness when removing front wheel speed sensor.
-
Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
Installation
1. Check that no foreign material is attached to sensor (1) and sensor ring (2).
2. Install it by reversing removal procedure.
Tightening torque
Front wheel speed sensor bolt (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
CAUTION: Do not pull or twist wire harness more than necessary when installing front wheel speed sensor.
3. Check that there is no clearance between sensor and knuckle.