Aerio L4-2.3L (2006)
6. Install mounting member. Tighten bolts and nuts to specified torque.
Tightening torque
Engine mounting bolts and nuts (a): 55 Nm (5.5 kgf-m, 40.0 ft. lbs.)
Engine front and rear mounting nuts (b): 45 Nm (4.5 kgf-m, 32.5 ft. lbs.)
7. Remove engine support jack.
8. Install exhaust No.1 pipe (1) Tighten bolts and nuts to specified torque.
Tightening torque
Exhaust manifold to No.1 pipe nuts (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
Exhaust No.1 pipe to No.2 pipe bolts (b): 43 Nm (4.3 kgf-m, 31.5 ft. lbs.)
Exhaust pipe No.2 stiffener bolts (c): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
NOTE:
^
Tighten bolts and nuts marked (a) first.
^
Use new gasket for exhaust No.1 pipe.
9. Install engine under covers.
10. Install oil level gauge.
11. Refill engine with engine oil.
Cleaning
^
Clean mating surface of oil pan and cylinder block
Remove oil, old sealant, and dust from mating surfaces and oil pan inside.
^
Clean oil pump strainer screen