Aerio L4-2.3L (2006)
WARRANTY CLAIM INFORMATION:
REPROGRAMMING PROCEDURE:
1. Log onto the Suzuki Pit Stop.
2. Download and review the Suzuki Pass-Thru Reprogramming Tool Operator's Manual. This must be read and understood COMPLETELY before
attempting to reprogram the ECM.
3. Following the procedure outlined in the Suzuki Pass-Thru Reprogramming Tool Operator's Manual, download and install the Pass-Thru
Reprogramming Software "3_SOFTWARE.EXE" if it is not already installed on your PC.
4. Download and unzip Suzuki Pass-Thru Reprogramming Data Base "4_DATABASE1.EXE" onto your PC. Follow the procedure in Section 3.2 of the
Operator's Manual to update the Database files.
This step is only required to be done once to accommodate all vehicles covered under this TSB.
NOTE:
The Database "4_DATABASE1.EXE" has been updated with newer data for reprogramming without changing the file name. You are requested to
download in order to update the database in your PC.
5. Following the procedures outlined in the Suzuki Pass-Thru Reprogramming Tool Operator's Manual, hook up the SDS Interface Tool P/N
09910-06520 to the vehicle DLC and run the ECM reprogramming software. If the message "[4028] ECU already has the latest version" appears, click
"OK" and "Finish" and then continue to step 6.
NOTE:
If you believe the code "[4028] ECU already has the latest version" is false, check that the Database has been properly installed. Repeat step 4 and then
try reprogramming again. If after installing the Database properly code 4028 appears again, no further action is required.
