Aerio L4-2.3L (2006)
Repairs and Inspections Required After a Collision: Service and Repair
Restraints - Advanced Air Bag Diagnostics
Inspection And Repair Required After Accident
CAUTION:
-
All air bag system components, including the electrical harness (component mounting points), must be inspected after an accident. If any
components are damaged or bent, they must be replaced even if air bag system activation did not occur.
-
Never use air bag system parts from another vehicle.
-
Do not attempt to service the parts below. Service of these parts is by replacement only.
-
Driver / Passenger air bag (inflator) modules
-
Driver / Passenger side air bag (inflator) modules
-
Driver / Passenger seat belt pretensioners
-
Forward sensors
-
Side sensors
-
SDM
-
Contact coil and combination switch assembly
-
Air bag wire harness in main harness, instrument panel harness, floor harness and seat harness.
-
OCM
-
Front passenger seat adjuster with weight sensor.
-
Driver seat position sensor
-
Driver / passenger seatbelt buckle sensor
-
Proper operation of the sensors and air bag system requires that any repairs to the vehicle structure return it to its original production
configuration.
CAUTION: After detecting one time of such collision as to meet deployment conditions, the SDM must not be used. Refer to Air Bag
Diagnostic System Check: Advanced Air Bag when checking the SDM. See: Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics/Diagnostic Strategies/With Advanced Air Bag/Air Bag Diagnostic System Check
Accident with Deployment / Activation Component Replacement
When driver and passenger air bags are deployed, the following components must be replaced.
-
Driver and passenger air bag (inflator) modules
-
Driver and passenger seat belt pretensioners
-
SDM after detecting such collision as to meet deployment conditions Forward sensors
-
Instrument panel
When side air bag is deployed, the following components must be replaced.
-
Applicable side air bag (inflator) module
-
Side sensor
-
SDM
Accident with or without Deployment / Activation Component Inspections
Certain air bag and restraint system components must be inspected after any crash, whether the air bag system activated or not. If any faulty condition is
found in the following checks, replace faulty part. Those components are:
-
Steering column (1) and shaft joints
-
Check for length, damage and bend according to Checking Steering Column Assembly for Accident Damage.
