Aerio L4-2.3L (2006)
^
Install ABS wheel speed sensor (1) (if equipped with ABS).
Tightening torque
ABS wheel speed sensor mounting bolt (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)
^
Connect tie-rod end (1) to steering knuckle (2) and tighten tie-rod end castle nut (3) to specified torque.
Tightening torque
Tie-rod end castle nut (a): 45 Nm (4.5 kgf-cm, 32.5 ft. lbs.)
^
Install new split pin (4).
^
Install brake caliper (3).
^
Tighten caliper carrier bolt to specified torque.
Tightening torque
Caliper carrier bolt 85 Nm (8.5 kgf-cm, 61.5 ft. lbs.)
^
Depress foot brake pedal and hold it there.
^
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (a): 175 Nm (17.5 kgf-cm, 127.0 ft. lbs.)
CAUTION: Never reuse drive shaft nut (1).
^
Caulk drive shaft nut (1) as shown.
CAUTION: Be careful while caulking nut so that no crack will occur in caulked part of nut. Cracked nut must be replaced with new one.
^
Tightening wheel nut to specified torque.
Tightening torque
Wheel nut 85 Nm (8.5 kgf-cm, 61.5 ft. lbs.)
