Aerio L4-2.3L (2006)
3. Aligning clutch disc with flywheel center by using special tool, install clutch cover (1) and bolts (2). Then tighten bolts (2) to specification.
NOTE:
^
While tightening clutch cover bolts, compress clutch disc with special tool (clutch center guide) by hand so that disc is centered.
^
Tighten cover bolts little by little evenly in diagonal order.
Special Tool
(A): 09924-17811
(B): 09923-36320
Tightening torque
Clutch cover bolts (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)
4. Slightly apply grease to input shaft (1), then join transaxle assembly with engine.
"A": Grease 99000-25210
NOTE: When inserting transaxle input shaft to clutch disc, turn crankshaft little by little to match the splice mesh.
