Aerio L4-2.3L (2006)
Clutch Master Cylinder: Service and Repair
Disassembly and Reassembly
Disassembly
1. Remove boot (1) and then circlip (2) with piston rod (3) pushed in.
2. Blow compressed air gradually into hole for pipe connection to remove piston assembly (1), using care to prevent it from jumping out.
Reassembly
NOTE: Before installation, wash each part in specified brake fluid.
1. Apply brake fluid to piston assembly and inside of cylinder body.
2. Install piston assembly into cylinder.
3. With piston pushed rod (3) down, install circlip (2) as shown.
4. Install boot (1).
Inspection
Inspect all disassembled parts for wear or damage, and replace parts if necessary.
NOTE:
^
Wash disassembled parts with brake fluid.
^
Do not reuse piston assembly and circlip.