Aerio AWD L4-2.0L (2003)
7) Place disassembled parts except valve stem seal and valve guide in order so that they can be installed in their original positions.
Assembly
1) Before installing valve guide into cylinder head, ream guide hole with special tool (11 mm reamer) so as to remove burrs and make it truly round.
Special Tool
(A): 09916-34542
(B): 09916-38210
2) Install valve guide to cylinder head.
Heat cylinder head uniformly at a temperature of 80 to 100 °C (176 to 212°F) so that head will not be distorted, and drive new valve guide into
hole with special tools.
Drive in new valve guide until special tool contacts cylinder head.
After installing, make sure that valve guide protrudes by 13.5 mm (0.53 inch) from cylinder head.
Special Tool
(A): 09916-58210
(B): 09917-87810
NOTE:
^
Do not reuse valve guide once disassembled. Install new valve guide (Oversize).
^
Intake and exhaust valve guides are identical.
Valve guide oversize: 0.03 mm (0.0012 inch)
Valve guide protrusion "a" (In and Ex): 13.5 mm (0.53 inch)
