Aerio AWD L4-2.0L (2003)
11.
Lower the vehicle and reinstall the P/S pump and two rear P/S mounting bolts finger tight.
12.
Now thread in the two front P/S mounting bolts. Torque all four P/S mounting bolts to 25 Nm (18 lb-ft).
13.
Install the new Serpentine belt. Use the figure in step 5 as a belt routing reference. Be sure to clean the P/S Pump Pulley grooves with a wire brush
and a suitable degreaser.
14.
Be sure the IAT sensor is located away from any rotating parts of the engine. Reconnect the negative battery cable. Start the engine briefly to allow
the belt to seat in place then stop the engine.