Equator 2WD V6-4.0L (2009)
Hood Latch: Service and Repair
Hood Lock Control: Removal And Installation
REMOVAL
1. Remove the front grille. Refer to [Front Grille: Removal and Installation].
2. Remove the front fender protector (LH). Refer to [Front Fender Protector: Removal and Installation].
3. Disconnect the hood lock cable from the hood lock, and unclip it from the radiator core support upper and hoodledge.
4. Remove the bolts, and the hood release handle.
5. Separate the grommet from the lower dash panel. Pull the hood lock cable out through the passenger compartment.
CAUTION: While pulling, be careful not to damage the outside of the hood lock cable.
INSTALLATION
1. Pull the hood lock cable through the lower dash panel hole into the engine room.
CAUTION: Be careful not to bend the cable too much, keep the radius 100mm (3.94 in) or more.