Equator 2WD V6-4.0L (2009)
Brakes and Traction Control > Antilock Brakes / Traction Control Systems > Wheel Speed Sensor > Component Information > Service and Repair > Type 1 (ABS) > Page 3067
1) Remove the axle shaft assembly.
Tool number: ST30031000 ( - )
1) Install the new sensor rotor on the axle shaft using a suitable length steel tube and a press. Make sure the sensor rotor is fully seated.
Do not reuse the old sensor rotor.
2) Install the axle shaft assembly.
Do not reuse the axle oil seal. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft
|[PREV PAGE] [NEXT PAGE]|