Equator 2WD V6-4.0L (2009)
Instrument Panel, Gauges and Warning Indicators > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Removal and Replacement > Page 4942
3. Check the fuel level on level gauge. If the fuel gauge indicates more than the level as shown (full or almost full), drain the fuel from the fuel tank
until the fuel gauge indicates the level as shown, or less.
NOTE: Fuel will be spilled when removing the fuel level sensor, fuel filter, and fuel pump assembly for the fuel level is above the fuel level
As a guide, the fuel level reaches the fuel gauge position as shown, or less, when approximately 15 l (4 US gal, 3 1/4 Imp gal) of fuel are
If the fuel pump does not operate, use the following procedure to drain the fuel to the specified level.
a. Insert a suitable hose of less than 15 mm (0.59 in) diameter into the fuel filler pipe through the fuel filler opening to drain the fuel from fuel
b. Remove the fuel filler pipe shield.
4. Release the fuel pressure from the fuel lines. Refer to [Fuel Pressure Check: (QR25DE), (VQ40DE)].
|[PREV PAGE] [NEXT PAGE]|