Equator 2WD V6-4.0L (2009)
Powertrain Management > Computers and Control Systems > Engine Control Module > Component Information > Diagrams > ECM Harness Connector Terminal Layout > Page 1743
Engine Control Module: Diagrams
ECM Terminal and Reference Value
ECM located in the engine room passenger side behind reservoir tank.
ECM INSPECTION TABLE
Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by SDT.
CAUTION: Never use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor.
|[PREV PAGE] [NEXT PAGE]|