Workshop Repair Manuals

Suzuki Workshop Manuals

[PREV PAGE] [NEXT PAGE]

suzuki Workshop Repair Guides


Equator 2WD V6-4.0L (2009)

Powertrain Management > Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Procedure After Replacing ECM

Page 1
background image

Engine Control Module: Service and Repair
Procedure After Replacing ECM

Procedure After Replacing ECM

When replacing ECM, the following procedure must be performed.

1. Perform initialization of immobilizer system and registration of all immobilizer system ignition key IDs. Refer to [Additional Service When

Replacing Control Unit: Special Repair Requirement].  See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning

2. Perform "VIN Registration" in [Procedure After Replacing ECM].  See: Testing and Inspection/Programming and Relearning/VIN Registration
3. Perform "Accelerator Pedal Released Position Learning" in [Procedure After Replacing ECM].  See: Testing and Inspection/Programming and

Relearning/Accelerator Pedal Released Position Learning

4. Perform "Throttle Valve Closed Position Learning" in [Procedure After Replacing ECM].  See: Testing and Inspection/Programming and

Relearning/Throttle Valve Closed Position Learning

5. Perform "Idle Air Volume Learning" in [Procedure After Replacing ECM].  See: Testing and Inspection/Programming and Relearning/Idle Air

Volume Learning

Powertrain Management > Computers and Control Systems > Engine Control Module > Component Information > Service and Repair > Procedure After Replacing ECM

[PREV PAGE] [NEXT PAGE]