Equator 2WD V6-4.0L (2009)
Powertrain Management > Computers and Control Systems > Information Bus > Component Information > Service Precautions > Precaution For Trouble Diagnosis > Page 1801
Information Bus: Service Precautions
Precaution for Harness Repair
Solder the repaired area and wrap tape around the soldered area.
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
|[PREV PAGE] [NEXT PAGE]|