Equator 2WD V6-4.0L (2009)
Powertrain Management > Fuel Delivery and Air Induction > Fuel Injector > Component Information > Service and Repair > Exploded View > Page 2093
d. Tighten bolts evenly in turn.
After tightening bolts, make sure that there is no gap between fuel damper cap and fuel tube.
2. Install new O-rings to fuel injector, paying attention to the following.
Upper and lower O-ring are different colors.
Fuel tube side : Blue
Handle O-ring with bare hands. Never wear gloves.
Lubricate O-ring with new engine oil.
Do not clean O-ring with solvent.
Make sure that O-ring and its mating part are free of foreign material.
When installing O-ring, be careful not to scratch it with tool or fingernails.
Do not twist or stretch O-ring. If O-ring was stretched while it was being attached, allow it to retract before inserting it into fuel tube.
Insert O-ring straight into fuel injector. Do not angle or twist it.
3. Install fuel injector to fuel tube.
|[PREV PAGE] [NEXT PAGE]|