Equator 2WD V6-4.0L (2009)
Seat Belt: Testing and Inspection
Front Seat Belt: Seat Belt Inspection
Front Seat Belt: Seat Belt Inspection
AFTER A COLLISION
WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision.
SUZUKI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no
damage and continue to operate properly. Failure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use
during a collision should also be replaced if either damage or improper operation is noted. Seat belt pre-tensioners should be replaced even if
the seat belts are not in use during a frontal collision in which the air bags are deployed.
Replace any seat belt assembly (including anchor bolts) if:
-
The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to
operate properly).
-
The seat belt was damaged in an accident. (i.e. torn webbing, bent retractor or guide).
-
The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair as necessary
before installing a new seat belt assembly.
-
Anchor bolts are deformed or worn out.
-
The seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in which the air bags are deployed.
PRELIMINARY CHECKS
1. Check the seat belt warning lamp/chime for proper operation as follows:
a. Switch ignition ON. The seat belt warning lamp should illuminate. Also, the seat belt warning chime should sound for about seven seconds.
b. Fasten driver's seat belt. The seat belt warning lamp should go out and the chime (if sounding) should stop.
2. If the air bag warning lamp is blinking, conduct "DTC check" using SDT, and air bag warning lamp. Refer to [SRS Operation Check]. See:
Testing and Inspection/Component Tests and General Diagnostics
3. Check that the seat belt retractor, seat belt anchor and buckle bolts are securely attached.
4. Check the shoulder seat belt guide and shoulder belt height adjuster for front seats. Ensure guide swivels freely and that belt lays flat and does not
bind in guide. Ensure height adjuster operates properly and holds securely.
5. Check retractor operation:
a. Fully extend the seat belt webbing and check for twists, tears or other damage.
b. Allow the seat belt to retract. Ensure that belt returns smoothly and completely into the retractor. If the seat belt does not return smoothly, wipe
the inside of the loops with a clean paper cloth, because dirt built up in the loops of the upper anchors can cause the seat belts to retract slowly.
c. Fasten the seat belt. Check the seat belt returns smoothly and completely to the retractor. If the belt does not return smoothly, the cause may be
an accumulation of dust or dirt. Use the "SEAT BELT TAPE SET" and perform the following steps.
Inspect the front seat belt through-anchor:
1. Pull the seat belt out to a length of 500 mm (19.69 in) or more.
2. Use a clip or other device to hold the seat belt at the center pillar belt opening.
3. Pass a thin wire through the through-anchor belt opening. Hold both ends of the wire and pull taut while moving it up and down several
times along the belt opening surface to remove dirt.
4. Any dirt that cannot be removed with the wire can be removed by cleaning the opening with a clean cloth.
5. Apply tape at the point where the belt contacts the through-anchor belt opening.
NOTE: Apply the tape so that there is no looseness or wrinkling.
6. Remove the clip holding the seat belt and check that the belt returns smoothly.
7. Repeat steps above as necessary to check the other seat belts.