Workshop Repair Manuals

Suzuki Workshop Manuals

[PREV PAGE] [NEXT PAGE]

suzuki Workshop Repair Guides


Equator 2WD V6-4.0L (2009)

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Type 1 (ABS) > Page 298

Page 2
background image

1) Remove the axle shaft assembly.
2) Pull the sensor rotor off of the axle shaft using Tool and a suitable press.

Tool number: ST30031000 ( - )

Installation 

1) Install the new sensor rotor on the axle shaft using a suitable length steel tube and a press. Make sure the sensor rotor is fully seated.

CAUTION:

Do not reuse the old sensor rotor. 

2) Install the axle shaft assembly.

CAUTION:

Do not reuse the axle oil seal. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft
housing.
 

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Type 1 (ABS) > Page 298

[PREV PAGE] [NEXT PAGE]