Equator 2WD V6-4.0L (2009)
Sensors and Switches > Sensors and Switches - Restraint Systems > Impact Sensor > Component Information > Service and Repair > Crash Zone Sensor > Page 467
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor: Removal And Installation
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
3. Remove side air bag (satellite) sensor nuts and release the clip.
Do not use old nuts after removal; replace with new nuts.
Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace
Do not disassemble side air bag (satellite) sensor.
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
Installation is in the reverse order of removal.
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to [SRS Operation Check].
|[PREV PAGE] [NEXT PAGE]|