Equator 2WD V6-4.0L (2009)
13) Remove steering knuckle from vehicle.
INSPECTION AFTER REMOVAL
Check for deformity, cracks and damage on each part, replace if necessary.
^
Perform ball joint inspection. Refer to [Upper Ball Joint and Lower Ball Joint: Inspection].
INSTALLATION
Installation is in the reverse order of removal.
^
For 4WD models, refer to [Drive Shaft: Removal and Installation] for drive shaft lock nut tightening torque.
CAUTION:
Always replace drive shaft lock nut and cotter pin.
^
Refer to [Steering Gear and Linkage: Disassembly and Assembly] for outer socket nut tightening torque.
^
Refer to [Front Suspension Assembly: Component] for front suspension tightening torques.
^
When installing disc rotor on wheel hub and bearing assembly, align the marks.