Equator 2WD V6-4.0L (2009)
Clutch Disc: Service and Repair
6M/T
Clutch Disc, Clutch Cover: Removal and Installation
Clutch Disc, Clutch Cover: Removal and Installation [6M/T]
CAUTION:
^
Do not clean the clutch disc with solvent.
^
When installing, do not get grease from the main drive shaft onto the clutch disc friction surface.
^
If the flywheel is removed, align the dowel pin with the smallest hole of flywheel.
REMOVAL
1) Remove the manual transmission from the vehicle.
2) Remove the clutch cover bolts using power tool. Remove the clutch cover and clutch disc.
INSTALLATION
1) Apply recommended grease to clutch disc and main drive shaft spline.
CAUTION:
Do not allow grease to contaminate the clutch facing.
2) Install clutch disc and clutch cover. Pre-tighten the bolts and install Tool. Then tighten the clutch cover bolts evenly in two steps to the specified
torque in the order shown.