Workshop Repair Manuals

Suzuki Workshop Manuals

[PREV PAGE] [NEXT PAGE]

suzuki Workshop Repair Guides


Equator 2WD V6-4.0L (2009)

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Drive/Propeller Shaft > Component Information > Service and Repair > Removal and Replacement > Page 2785

Page 10
background image

2WD :0.6 mm (0.024 in) or less
4WD :1.02 mm (0.0402 in) or less

^

While holding the flange yoke on one side, check axial play of the joint as shown. If the journal axial play exceeds the specification, repair or
replace the journal parts.

Journal axial play: 0.02 mm (0.0008 in) or less

^

Check the propeller shaft for dents or cracks. If damage is detected, replace the propeller shaft assembly.

INSTALLATION

Installation is in the reverse order of removal.
^

After installation, check for vibration by driving the vehicle.

CAUTION:
Do not reuse the bolts and nuts. Always install new ones.

3S1330 Type

Rear Propeller Shaft: Removal and Installation

COMPONENTS

Model 3S1330

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Drive/Propeller Shaft > Component Information > Service and Repair > Removal and Replacement > Page 2785

[PREV PAGE] [NEXT PAGE]