Workshop Repair Manuals

Suzuki Workshop Manuals

[PREV PAGE] [NEXT PAGE]

suzuki Workshop Repair Guides


Equator 2WD V6-4.0L (2009)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Bearing > Component Information > Service and Repair > Rear (C200 Type) > Page 2689

Page 11
background image

CAUTION:
When inserting axle shaft, be careful not to damage oil seal.

NOTE:
The split ends of the Tool must butt up together and not overlap as shown.

Tool number: - (J-34296-1 part of J-46215)

17) Insert the axle shaft assembly. Tighten the axle shaft nuts evenly in a criss-cross pattern to specification. 

^

Remove the Tool when the axle shaft assembly is approximately 90% inserted to protect the new axle oil seal.

Tool number: - (J-34296-1 part of J-46215)

18) Install the parking brake assembly on the back plate and torque member. 
19) Install the rear brake caliper assembly. 
20) Install the ABS wheel sensor into the axle case.

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Bearing > Component Information > Service and Repair > Rear (C200 Type) > Page 2689

[PREV PAGE] [NEXT PAGE]