Equator 2WD V6-4.0L (2009)
Transmission and Drivetrain > Manual Transmission/Transaxle > Fluid - M/T > Component Information > Service and Repair > Procedures > Page 2865
CAUTION: Do not start engine while checking oil level.
3. Set a gasket on the filler plug and install it to the transmission. Tighten the filler plug to the specified torque. Refer to [Transmission Assembly:
Disassembly and Assembly].
CAUTION: Do not reuse gasket.
M/T Oil Changing [FS5R30A]
1) Start the engine and let it run to warm up the transmission.
1) Remove the filler plug. Fill with new oil until oil level reaches the specified limit near the filler plug hole.
|[PREV PAGE] [NEXT PAGE]|