Equator 4WD V6-4.0L (2010)
Front Door Panel: Service and Repair
Door Finisher: Removal and Installation
Front Door
Removal
1. Remove window crank handle or power window switch assembly, (if equipped).
-
Disconnect harness connectors.
2. Remove pull handle escutcheon.
3. Remove pull handle cover, then remove door finisher screw.
4. Lift armrest upward to release clips and remove armrest.
-
Remove screws behind armrest.
5. Release clips and remove door finisher.
6. Remove pull handle/lock lever assembly.
-
Disconnect lock lever cable and pull handle cable from lever assembly. Refer to [Front Door Lock: Removal and Installation].
Installation