Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
Tightening Torque (a): 35 Nm (25.5 ft. lbs.)
5. Remove cap and using a scale on gaging plastic envelope, measure gaging plastic width at the widest point (clearance). If clearance exceeds its
limit, use a new standard size bearing and remeasure clearance.
Bearing Clearance:
Standard: 0.020 - 0.050 mm (0.0008 - 0.0019 inch)
Limit: 0.080 mm (0.0031 inch)
6. If clearance can not be brought to within its limit even by using a new standard size bearing, regrind crankpin to undersize and use 0.25 mm
undersize bearing.
Assembly
NOTE: Two sizes of piston are available as standard size spare part so as to ensure proper piston-to-cylinder clearance. When installing a
standard size piston, make sure to match piston with cylinder as follows.
a. Each piston has stamped number 1 or 2 as shown. It represents outer diameter of piston.
b. There are also stamped numbers of 1 and 2 on the cylinder block as shown. The first number represents inner diameter of No.1 cylinder, the
second number of No.2 cylinder, the third number of No.3 cylinder and the fourth number of No.4 cylinder.
