Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
3. Check to make sure that ball makes creaking noise when shaking the reverse clutch piston. (i.e., check that ball is free.)
4. Check that there is no leakage by applying low-pressure air onto ball.
5. Check that outer surface of reverse clutch with bearing is not worn or burnt. If necessary, replace.
ASSEMBLY
1. Apply fluid to new O-rings.
2. Install them to reverse clutch piston.
3. Press reverse clutch piston into reverse clutch drum with bearing with cup side up.
NOTE: Do not twist or deviate O-rings during installation.