Esteem GL Sedan L4-1.8L (1999)
4. Remove reservoir pin or bolt. Use special tool for pin removal.
Special Tool (A): 09922-85811
5. Remove reservoir.
CAUTION: Brake fluid is extremely damaging to paint. Do not allow brake fluid to goat on painted surfaces.
INSTALLATION
NOTE:
^
When inspecting and servicing vehicle equipped with ABS, be sure to refer "Antilock Brake System" first.
^
All brake fasteners are important attaching parts in that they could affect the performance of vital parts and systems, and/or could result in major
repair expense. They must be replaced with one of same part number or with an equivalent part if replacement becomes necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to assure proper retention of all
parts. There is to be no welding as it may result in extensive damage and weakening of the metal.
1. When using new grommets, lubricate them with the same fluid as the one to fill reservoir with. Then press-fit grommets to master cylinder.
Grommets must be seated in place.
2. Install reservoir and drive in reservoir pin or tighten reservoir bolt.
NOTE: Drive in reservoir pin till both of its ends at the right and left or reservoir becomes the same length.
3. Connect reservoir lead wire.
4. Fill reservoir with specified fluid.
5. Upon completion of installation, check for fluid leakage.
Assembly
