Esteem GL Sedan L4-1.8L (1999)
2. After removing joint covers, loosen steering shaft upper joint bolt (but it must not be removed) and remove lower joint bolt.
CAUTION: Be sure to set front wheels (tires) in straight direction and remove ignition key from key cylinder before following steps, otherwise
contact coil of airbag system may get damaged.
3. With front wheels in straight-ahead position, separate pinion and lower joint.
4. Jack up vehicle and remove both right and left wheels.
5. Remove split pin and then remove tie rod castle nut from steering knuckle.
6. Using special tool, remove tie rod end from knuckle.
Special Tool
(A): 09913-65210
7. For M/T model: Disconnect gear shift control shaft and extension rod from transmission.
